Posted on

Florafelt Pro System Living Wall Installation by Lindsey Graves of Living Green Design

Lindsey Graves of Living Green Design used the Florafelt Pro System to create this living wall installation. Stainless steel grids were mounted to the wall then the water shield is inserted. For this install a custom recirculation system was added to use water from the pond below. Florafelt Grow Strip is then woven in then Florafelt Root Wrapped plants are added.

Lindsey Graves of Living Green Design.

Wire grids are added attached to the stucco wall using stainless clips and Tapcon concrete screws.

Florafelt Pro System irrigation tubing.

Water shields are inserted and irrigation tubing is attached to the top of the grid using zip ties. For this recirculating system, 3/8″ holes are drilled into the tubing above each grid column.

This image has an empty alt attribute; its file name is FlorafeltProSystemlivingwallbyLindseyGravesLivingGreenDesign8-735x980.jpg
Florafelt Grow strip weaving into a grid. US Patent 8141294.

Florafelt Grow strip is woven into the grid using the pleated method. A guide is used to make pocket depths consistent. This growing method is our proprietary method under US Patent 8141294.

Florafelt Pro System custom recirculating installation.

The Florafelt Pro System is ready to plant. The pond below will act as a water reservoir. Water will be recirculated using the pump below. A timer is located behind the wall. A hole behind the system is large enough to fit the submersible water pump’s 3-prong cord.

Lindsey Graves of Living Green Design.

Plants wrapped in Florafelt Root Wraps are added to the pockets to create a beautifully orchestrated design.

Florafelt Pro System design and install by Lindsey Graves of Living Green Design.